B0095 Code:

OBD-II Diagnostic Body (B) Trouble Code

Possible Cause

B0095 leads to an unsuccessful repair. Engine misfire codes, lean exhaust codes, fuel injector codes, and virtually any other drivability or transmission code that is accompanied by a controller communication code can potentially be a pitfall for misdiagnosis.

Common Symptoms

  1. Pay particular attention to wiring and connectors that have been contaminated due to engine oil or transmission fluid leaks, burned on hot exhaust pipes, or damaged due to road debris. Inconsistencies between the input and output speed sensor readings may be interpreted by the PCM as a transmission friction element application malfunction
  2. Begin your diagnosis with a visual inspection of system wiring, connectors, and components
  3. The PCM will read the sensor resistance and pass it
  4. If the transmission functions normally and the code doesn't return, then it was likely caused by transmission slippage due to a low fluid level/pressure condition. If the code returns and the transmission slips or suffers from delayed engagement, check pump pressure using a manual pressure gauge

Similar Problems

Accelerator Pedal Position (APP) Sensor 1 Performance
BBV Sensor Circuit Low Voltage
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit

B0095 Troubleshooting

When you put your foot down on the brakes you expect your car to quietly slow down and come to a stop. The power your foot applies on the brake pedal is assisted by hydraulic pressure. Your foot's force engages a piston and caliper with brake pads attached (bonded abrasive and heat resistance metal or ceramic) to put pressure on the rotor. B0095 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to turn off B0095 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | https://www.enginetroubles.com | All Rights Reserved.