Ssangyong W U3132 Code:

OBD-II Diagnostic Network (U) Trouble Code

Trouble In Ssangyong W U3132 Possible Cause

To know real cause of Ssangyong W U3132 based of if this code is present in your two-wheel drive vehicle, suspect a faulty PCM or programming error. In most four wheel drive applications the four-wheel drive switch is used to switch between two and four wheel drive operation, as well as between low and high ranges

Common Symptoms For Ssangyong W U3132

  1. The PCM calculates input data and regulates transmission fluid pressure via a specially designed pressure control solenoid. The automatic transmission uses a high pressure pump (driven by the engine via the torque converter) to circulate fluid through the transmission hydraulic circuits in the transmission housing and valve body
  2. As the input shaft is turned (by the engine) the electro magnetic input/turbine speed sensor uses the spaces between the splines to provide voltage signal interruptions in the circuit
  3. Several tools will be instrumental in successfully diagnosing this code
  4. Several tools will be instrumental in successfully diagnosing this code

Similar Problems

Transmission
Crankshaft Position Sensor Circuit Performance
Cruise Control System - Vehicle Accel Too High

Ssangyong W U3132 Troubleshooting

Having one of the signs of a bad gasket is usually not enough to prove a failure of a gasket, but multiple symptoms are most likely the result of gasket failure. It is advisable to have the vehicle driven as little as possible whenever the symptoms occur. Depending on the symptoms, either have the gasket replaced or repaired.
The cost of replacing a gasket usually varies from one mechanic to the other. Replacing a gasket is quite expensive in modern engines due to their location and the amount of labor that is required to replace them. Ssangyong W U3132 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to turn off Ssangyong W U3132 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | https://www.enginetroubles.com | All Rights Reserved.