Rochdale Olympic P2851 Code:

OBD-II Diagnostic Powertrain (P) Trouble Code

Trouble In Rochdale Olympic P2851 Possible Cause

The most common causes of Rochdale Olympic P2851 code being stored are due to a defective intermediate shaft speed sensor, output speed sensor, or input speed sensor.

Common Symptoms For Rochdale Olympic P2851

  1. Individual control module failure is rare but possible
  2. A suitable OBD-II scanner (or code reader) and a digital volt/ohmmeter will be most helpful in performing a successful diagnosis
  3. Some applications are equipped with up to 18 separate control modules. If you choose to tackle this monumental task, begin with a careful visual inspection of all system circuitry, connectors, and fuses
  4. Check local, state, and federal laws before removing emission related components.

Similar Problems

Computer And Auxiliary Outputs
Low Coolant Circuit
Cruise Vehicle Speed/Set Speed Difference Too High

Rochdale Olympic P2851 Troubleshooting

If this is the case with the code, you will be hearing very loud noises, like explosions, from the rear of the vehicle upon acceleration. Firstly check the carburetor to ensure that the fuel and air combination are properly balanced. If these settings are correct, then thoroughly inspect the distributor cap for any cracks or hairline splits, as this can produce a backfire. Move on to the spark plugs and ensure that they are clean and undamaged and inspect the engine gaskets for any sign of damage, as they are responsible for ensuring the correct gas exchange within the engine. Rochdale Olympic P2851 OBD2 reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.

How to turn off Rochdale Olympic P2851 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | https://www.enginetroubles.com | All Rights Reserved.