Metallurgique 26 P245D Code:

OBD-II Diagnostic Powertrain (P) Trouble Code

Trouble In Metallurgique 26 P245D Possible Cause

The most likely cause of Metallurgique 26 P245D code being stored is a defective automatic transmission cooler control valve or valve position sensor. Other causes may include corroded, open, or shorted wiring or connectors, a loose control module ground strap, or broken ground wire.

Common Symptoms For Metallurgique 26 P245D

  1. Inspect electrical connectors for loose or damaged connectors or wiring
  2. If either the reference voltage or ground circuits are open, use the digital volt/ohmmeter to check for continuity (disconnect all related control modules from the circuit before checking circuit resistance or controller damage may occur) and resistance in all circuits
  3. This signal is systematically forwarded to affected control modules that utilize the data to accomplish various other tasks
  4. If the code fails to immediately return, you may have an intermittent condition

Similar Problems

Ignition System Or Misfire
Low Coolant Circuit
TFP Valve Position Switch-Drive Without Drive Ratio

Metallurgique 26 P245D Troubleshooting

Broken engine mountings can cause banging and graunching noises. There are two main types of mounting those centrally placed close to the bottom of the block and those higher up the block which mount on to the inner wings or chassis members. Metallurgique 26 P245D OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to turn off Metallurgique 26 P245D check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | https://www.enginetroubles.com | All Rights Reserved.