Matra M530 P0C0E Code:

OBD-II Diagnostic Powertrain (P) Trouble Code

Trouble In Matra M530 P0C0E Possible Cause

The most likely cause of Matra M530 P0C0E code being stored is a defective automatic transmission cooler control valve or valve position sensor. Other causes may include corroded, open, or shorted wiring or connectors, a loose control module ground strap, or broken ground wire.

Common Symptoms For Matra M530 P0C0E

  1. Look for loose or corroded electrical connectors that may increase circuit resistance and cause these types of codes to be stored. Obtain a CAN bus system wiring diagram and/or pin out value chart, then use the digital volt ohmmeter to test continuity between individual controller connectors
  2. Unlike other diagnostic codes, this type of code can sometimes be best left to a professional simply because of the bulk of circuitry involved
  3. If the fluid smells or appears burned, remove the transmission pan and check for the presence of clutch material and other debris
  4. Typical causes of low pump pressure include clogged hydraulic passages, a defective pump, faulty shift solenoids, or a faulty electronic pressure regulator

Similar Problems

Transmission
Control Module Throttle Actuator Position Performance
TFP Valve Position Switch-Drive Without Drive Ratio

Matra M530 P0C0E Troubleshooting

When you put your foot down on the brakes you expect your car to quietly slow down and come to a stop. The power your foot applies on the brake pedal is assisted by hydraulic pressure. Your foot's force engages a piston and caliper with brake pads attached (bonded abrasive and heat resistance metal or ceramic) to put pressure on the rotor. Matra M530 P0C0E OBD2 reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.

How to turn off Matra M530 P0C0E check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | https://www.enginetroubles.com | All Rights Reserved.