Lancia Scorpion U0980 Code:

OBD-II Diagnostic Network (U) Trouble Code

Trouble In Lancia Scorpion U0980 Possible Cause

The most likely cause of Lancia Scorpion U0980 code being stored is a defective automatic transmission cooler control valve or valve position sensor. Other causes may include corroded, open, or shorted wiring or connectors, a loose control module ground strap, or broken ground wire.

Common Symptoms For Lancia Scorpion U0980

  1. A suitable OBD-II scanner (or code reader), a digital volt/ohmmeter, and an oscilloscope will be most helpful in performing a successful diagnosis
  2. Look for shorted or burned wiring and replace circuitry and connectors as required
  3. Some applications also utilize the inlet door to regulate air flow through the intake tube by adjusting the degree to which the door opens according to throttle position
  4. To perform a thorough diagnosis, any transmission leaks should be repaired and the transmission should be filled with the proper amount and type of fluid (if the fluid smells really "burnt" and you are experienced enough to detect it, you may go ahead and condemn the transmission)

Similar Problems

IC Module 4X Ref Circuit Intermittent, No Pulses
TP Sensor Learn Not Complete
Transmission Engaged At High Throttle Angle

Lancia Scorpion U0980 Troubleshooting

Having one of the signs of a bad gasket is usually not enough to prove a failure of a gasket, but multiple symptoms are most likely the result of gasket failure. It is advisable to have the vehicle driven as little as possible whenever the symptoms occur. Depending on the symptoms, either have the gasket replaced or repaired.
The cost of replacing a gasket usually varies from one mechanic to the other. Replacing a gasket is quite expensive in modern engines due to their location and the amount of labor that is required to replace them. Lancia Scorpion U0980 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to turn off Lancia Scorpion U0980 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | https://www.enginetroubles.com | All Rights Reserved.