Hyundai Tiburon P1136 Code:

OBD-II Diagnostic Powertrain (P) Trouble Code

Trouble In Hyundai Tiburon P1136 Possible Cause

Common causes of Hyundai Tiburon P1136 include a faulty electronic pressure control solenoid, hydraulic blockages inside the internal transmission fluid passages, mechanical internal transmission failures, low transmission fluid, dirty or contaminated transmission fluid, a faulty PCM or transmission control module.

Common Symptoms For Hyundai Tiburon P1136

  1. If the electronic pressure control solenoid fails to activate manually, replace the solenoid and retest the transmission control system.
  2. This will help to determine whether or not the malfunction is intermittent. After the codes are cleared, test drive the vehicle to see if the code returns
  3. This signal is systematically forwarded to affected control modules that utilize the data to accomplish various other tasks
  4. Should all system circuitry and sensors check out and the transmission is in good working order, suspect a faulty PCM but keep in mind that PCM failure is rare and PCM replacement will require reprogramming.

Similar Problems

Transmission
Crankshaft Position Sensor Circuit Performance
Cruise Inhibit Control Circuit

Hyundai Tiburon P1136 Troubleshooting

If this is the case with the code, you will be hearing very loud noises, like explosions, from the rear of the vehicle upon acceleration. Firstly check the carburetor to ensure that the fuel and air combination are properly balanced. If these settings are correct, then thoroughly inspect the distributor cap for any cracks or hairline splits, as this can produce a backfire. Move on to the spark plugs and ensure that they are clean and undamaged and inspect the engine gaskets for any sign of damage, as they are responsible for ensuring the correct gas exchange within the engine. Hyundai Tiburon P1136 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to turn off Hyundai Tiburon P1136 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | https://www.enginetroubles.com | All Rights Reserved.