Honda Fit U3593 Code:

OBD-II Diagnostic Network (U) Trouble Code

Trouble In Honda Fit U3593 Possible Cause

The most common causes of Honda Fit U3593 code being stored are due to a defective intermediate shaft speed sensor, output speed sensor, or input speed sensor.

Common Symptoms For Honda Fit U3593

  1. This signal is systematically forwarded to affected control modules that utilize the data to accomplish various other tasks
  2. Unlike other diagnostic codes, this type of code can sometimes be best left to a professional simply because of the bulk of circuitry involved
  3. If the initial resistance is within specifications, leave the leads of the digital volt/ohmmeter connected and heat the resistor with a heat gun
  4. Typical causes of low pump pressure include clogged hydraulic passages, a defective pump, faulty shift solenoids, or a faulty electronic pressure regulator

Similar Problems

Transmission
BBV Sensor Circuit Low Voltage
A/C System High Pressure High Temperature

Honda Fit U3593 Troubleshooting

White smoke means that the fuel that is being injected into the combustion chamber is not being burned properly. The common causes that produce white smoke range from something as simple as low engine compression or water in the fuel to the fuel pump timing being thrown off because something is starving the fuel from getting to the pump in the manner necessary for the pump to time and work correctly. Parts or components should not be replaced with reference to only a Honda Fit U3593 DTC. The vehicle service manual should be consulted for more information on possible causes of the fault, along with required testing.

How to turn off Honda Fit U3593 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | https://www.enginetroubles.com | All Rights Reserved.