Hispano Suiza Alfonso C3861 Code:

OBD-II Diagnostic Chassis (C) Trouble Code

Trouble In Hispano Suiza Alfonso C3861 Possible Cause

Hispano Suiza Alfonso C3861 code applies to vehicles equipped with dual clutch adaptive transmissions, automated manual transmissions, manual transmissions and automatic transmissions. Technicians also report the presence of excessive corrosion in the sensor connector as the cause of this code being stored.

Common Symptoms For Hispano Suiza Alfonso C3861

  1. At any rate, make sure that the fluid level is within manufacturer's specified recommendations and that the fluid is in good condition
  2. This signal is systematically forwarded to affected control modules that utilize the data to accomplish various other tasks
  3. Typical causes of low pump pressure include clogged hydraulic passages, a defective pump, faulty shift solenoids, or a faulty electronic pressure regulator
  4. As exhaust temperature decreases (with the engine off), circuit resistance increases and the feedback voltage signal to the PCM decreases

Similar Problems

Computer And Auxiliary Outputs
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage
Cruise Vehicle Speed/Set Speed Difference Too High

Hispano Suiza Alfonso C3861 Troubleshooting

When you put your foot down on the brakes you expect your car to quietly slow down and come to a stop. The power your foot applies on the brake pedal is assisted by hydraulic pressure. Your foot's force engages a piston and caliper with brake pads attached (bonded abrasive and heat resistance metal or ceramic) to put pressure on the rotor. Hispano Suiza Alfonso C3861 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to turn off Hispano Suiza Alfonso C3861 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | https://www.enginetroubles.com | All Rights Reserved.