Healey Sportsmobile C3345 Code:

OBD-II Diagnostic Chassis (C) Trouble Code

Trouble In Healey Sportsmobile C3345 Possible Cause

The reason of Healey Sportsmobile C3345 is system wiring, connectors, or other electrical components are also subject to failure. When this code is set, it is imperative that the transmission be checked prior to further vehicle operation.

Common Symptoms For Healey Sportsmobile C3345

  1. Always retest the system after repairs are completed to ensure success. If all system wiring, connectors, and components (Including fuses) appear to be in normal working order, connect the scanner (or code reader) to the diagnostic connector and record all stored codes and freeze frame data
  2. If either the reference voltage or ground circuits are open, use the digital volt/ohmmeter to check for continuity (disconnect all related control modules from the circuit before checking circuit resistance or controller damage may occur) and resistance in all circuits
  3. The exhaust gas temperature sensor is used in diesel engines, gasoline burning engines, and even turbocharged engines
  4. If the code fails to immediately return, you may have an intermittent condition

Similar Problems

Fuel And Air Metering (Injector Circuit Malfunctions Only)
IC Circuit High Voltage
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit

Healey Sportsmobile C3345 Troubleshooting

When you put your foot down on the brakes you expect your car to quietly slow down and come to a stop. The power your foot applies on the brake pedal is assisted by hydraulic pressure. Your foot's force engages a piston and caliper with brake pads attached (bonded abrasive and heat resistance metal or ceramic) to put pressure on the rotor. Healey Sportsmobile C3345 OBD2 specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.

How to turn off Healey Sportsmobile C3345 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | https://www.enginetroubles.com | All Rights Reserved.