Hansa 1100 P1233 Code:

OBD-II Diagnostic Powertrain (P) Trouble Code

Trouble In Hansa 1100 P1233 Possible Cause

Common causes of Hansa 1100 P1233 is include shorted, open, corroded, or damaged wiring circuits or connectors, faulty shift solenoid/s, defective engine drivability sensors (especially the engine temperature sensor), dirty or contaminated transmission fluid that restricts flow, defective valve body, a faulty PCM. PCM failure is rare.

Common Symptoms For Hansa 1100 P1233

  1. Inspect electrical connectors for loose or damaged connectors or wiring
  2. Test the wiring and connectors at the fuel shutoff valve to make sure that voltage and ground readings are near battery voltage
  3. Several tools will be instrumental in successfully diagnosing this code
  4. The sensor is of the electro magnetic design and uses a reluctor ring (or a specialized set of splines) on the input shaft as reference points

Similar Problems

Fuel And Air Metering
Crankshaft Position Sensor Circuit Performance
A/C System High Pressure High Temperature

Hansa 1100 P1233 Troubleshooting

Broken engine mountings can cause banging and graunching noises. There are two main types of mounting those centrally placed close to the bottom of the block and those higher up the block which mount on to the inner wings or chassis members. Hansa 1100 P1233 OBD2 reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.

How to turn off Hansa 1100 P1233 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | https://www.enginetroubles.com | All Rights Reserved.