Gray Model+O P0707 Code:

OBD-II Diagnostic Powertrain (P) Trouble Code

Trouble In Gray Model+O P0707 Possible Cause

Common causes of Gray Model+O P0707 include a faulty electronic pressure control solenoid, hydraulic blockages inside the internal transmission fluid passages, mechanical internal transmission failures, low transmission fluid, dirty or contaminated transmission fluid, a faulty PCM or transmission control module.

Common Symptoms For Gray Model+O P0707

  1. Replacement of virtually all of these control modules will require reprogramming
  2. If the resistance level does not decrease with heat and increase as it cools, replace the sensor. If everything has checked out thus far, turn the key to the "ON" position and test for the presence of a voltage (and a ground signal) at the exhaust gas temperature/pressure (or heated oxygen) sensor electrical connector
  3. The PCM will read the sensor resistance and pass it
  4. If the fuel shutoff switch and all system circuitry checks out, suspect a defective PCM (or other related controller)

Similar Problems

Vehicle Speed Control And Idle Control System
Control Module Throttle Actuator Position Performance
PCM Stack Overrun

Gray Model+O P0707 Troubleshooting

Having one of the signs of a bad gasket is usually not enough to prove a failure of a gasket, but multiple symptoms are most likely the result of gasket failure. It is advisable to have the vehicle driven as little as possible whenever the symptoms occur. Depending on the symptoms, either have the gasket replaced or repaired.
The cost of replacing a gasket usually varies from one mechanic to the other. Replacing a gasket is quite expensive in modern engines due to their location and the amount of labor that is required to replace them. Gray Model+O P0707 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to turn off Gray Model+O P0707 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | https://www.enginetroubles.com | All Rights Reserved.