Ford Bantam B0435 Code:

OBD-II Diagnostic Body (B) Trouble Code

Trouble In Ford Bantam B0435 Possible Cause

The most likely cause of Ford Bantam B0435 code being stored is a defective automatic transmission cooler control valve or valve position sensor. Other causes may include corroded, open, or shorted wiring or connectors, a loose control module ground strap, or broken ground wire.

Common Symptoms For Ford Bantam B0435

  1. The inlet door is typically closed when the key is placed in the OFF position and opened when the key is turned to the ON position
  2. As the input shaft is turned (by the engine) the electro magnetic input/turbine speed sensor uses the spaces between the splines to provide voltage signal interruptions in the circuit
  3. Many vehicle applications utilize an electronically controlled valve in the automatic transmission cooler lines to regulate the flow of fluid to the cooler itself
  4. Several tools will be instrumental in successfully diagnosing this code

Similar Problems

Ignition System Or Misfire
Crankshaft Position Sensor Circuit Performance
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit

Ford Bantam B0435 Troubleshooting

Having one of the signs of a bad gasket is usually not enough to prove a failure of a gasket, but multiple symptoms are most likely the result of gasket failure. It is advisable to have the vehicle driven as little as possible whenever the symptoms occur. Depending on the symptoms, either have the gasket replaced or repaired.
The cost of replacing a gasket usually varies from one mechanic to the other. Replacing a gasket is quite expensive in modern engines due to their location and the amount of labor that is required to replace them. Ford Bantam B0435 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to turn off Ford Bantam B0435 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | https://www.enginetroubles.com | All Rights Reserved.