Fiat Brava P2851 Code:

OBD-II Diagnostic Powertrain (P) Trouble Code

Trouble In Fiat Brava P2851 Possible Cause

Fiat Brava P2851code will be stored and a malfunction indicator lamp may be illuminated. Some vehicles will require multiple failure cycles in order for the malfunction indicator lamp to be illuminated.

Common Symptoms For Fiat Brava P2851

  1. If certain items appear to be damaged, burned, or corroded, repair or replace them as required, then reset the code and retest the system. If no burned, damaged, or shorted wiring or loose connectors are detected, disconnect the exhaust gas temperature/pressure (or heated oxygen) sensor connector and remove the exhaust gas temperature sensor
  2. A suitable OBD-II scanner (or code reader) and a digital volt/ohmmeter will be most helpful in performing a successful diagnosis
  3. Some applications are equipped with up to 18 separate control modules. If you choose to tackle this monumental task, begin with a careful visual inspection of all system circuitry, connectors, and fuses
  4. Check local, state, and federal laws before removing emission related components.

Similar Problems

Computer And Auxiliary Outputs
Low Coolant Circuit
Cruise Vehicle Speed/Set Speed Difference Too High

Fiat Brava P2851 Troubleshooting

Having one of the signs of a bad gasket is usually not enough to prove a failure of a gasket, but multiple symptoms are most likely the result of gasket failure. It is advisable to have the vehicle driven as little as possible whenever the symptoms occur. Depending on the symptoms, either have the gasket replaced or repaired.
The cost of replacing a gasket usually varies from one mechanic to the other. Replacing a gasket is quite expensive in modern engines due to their location and the amount of labor that is required to replace them. Fiat Brava P2851 OBD2 specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.

How to turn off Fiat Brava P2851 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | https://www.enginetroubles.com | All Rights Reserved.