P2498code will be stored and a malfunction indicator lamp may be illuminated. Some vehicles will require multiple failure cycles in order for the malfunction indicator lamp to be illuminated.
A suitable OBD-II scanner (or code reader) and a digital volt/ohmmeter will be most helpful in trying to perform a successful diagnosis
If either the reference voltage or ground circuits are open, use the digital volt/ohmmeter to check for continuity (disconnect all related control modules from the circuit before checking circuit resistance or controller damage may occur) and resistance in all circuits
Intermittent conditions can prove to be quite a challenge to diagnose and in extreme cases may have to be allowed to worsen before a correct diagnosis can be made. If the fuel shutoff valve has not been deactivated by a collision, use the digital volt/ohmmeter to test voltage and ground signals at the valve itself
If the code fails to immediately return, you may have an intermittent condition
Ignition System Or Misfire
BBV Sensor Circuit Low Voltage
Kick-Down Switch Failed Short
Broken engine mountings can cause banging and graunching noises. There are two main types of mounting those centrally placed close to the bottom of the block and those higher up the block which mount on to the inner wings or chassis members. P2498 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.
How to turn off P2498 check engine light ?
There are two ways to turn off the check engine light:
A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.