Possible causes of P100A include a faulty oxygen sensor, faulty electrical connector at the oxygen sensor, faulty or shorted wiring in the oxygen sensor circuit, a blown fuse for the oxygen sensor (if applicable), low or excessive fuel pressure, a vacuum leak on the engine, excessive exhaust leaks, or a faulty PCM.
If there is a clicking noise when you attempt to start the engine and the engine does not crank, it typically means there is something wrong with the battery, such as a low or discharged battery or corroded or loose battery cables. If the engine cranks when you attempt to start the car, but fails to turn over, this may mean there is a problem with the fuel or ignition. Other common reasons an engine may fail to start include a failure of the starter motor relay, a clogged fuel filter, a defective fuel pump or an ignition switch failure. Parts or components should not be replaced with reference to only a P100A DTC. The vehicle service manual should be consulted for more information on possible causes of the fault, along with required testing.
A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.
Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.