C2413 Code:

OBD-II Diagnostic Chassis (C) Trouble Code

Possible Cause

C2413 leads to an unsuccessful repair. Engine misfire codes, lean exhaust codes, fuel injector codes, and virtually any other drivability or transmission code that is accompanied by a controller communication code can potentially be a pitfall for misdiagnosis.

Common Symptoms

  1. If the code fails to immediately return, you may have an intermittent condition
  2. If either the reference voltage or ground circuits are open, use the digital volt/ohmmeter to check for continuity (disconnect all related control modules from the circuit before checking circuit resistance or controller damage may occur) and resistance in all circuits
  3. CAN is the abbreviation for "controller area network." The CAN represents a communication bus that allows multiple microcontrollers to communicate with one another without the need for a host computer
  4. Some applications also utilize the inlet door to regulate air flow through the intake tube by adjusting the degree to which the door opens according to throttle position

Similar Problems

Ignition System Or Misfire
Vehicle Speed Output Circuit
A/C System High Pressure High Temperature

C2413 Troubleshooting

If this is the case with the code, you will be hearing very loud noises, like explosions, from the rear of the vehicle upon acceleration. Firstly check the carburetor to ensure that the fuel and air combination are properly balanced. If these settings are correct, then thoroughly inspect the distributor cap for any cracks or hairline splits, as this can produce a backfire. Move on to the spark plugs and ensure that they are clean and undamaged and inspect the engine gaskets for any sign of damage, as they are responsible for ensuring the correct gas exchange within the engine. C2413 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to turn off C2413 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.