C2068 Code:

OBD-II Diagnostic Chassis (C) Trouble Code

Possible Cause

C2068code will be stored and a malfunction indicator lamp may be illuminated. Some vehicles will require multiple failure cycles in order for the malfunction indicator lamp to be illuminated.

Common Symptoms

  1. These types of codes are frequently caused by defective or disconnected system grounds
  2. This will help to determine whether or not the malfunction is intermittent. After the codes are cleared, test drive the vehicle to see if the code returns
  3. Some applications are equipped with up to 18 separate control modules. If you choose to tackle this monumental task, begin with a careful visual inspection of all system circuitry, connectors, and fuses
  4. Should all system circuitry and sensors check out and the transmission is in good working order, suspect a faulty PCM but keep in mind that PCM failure is rare and PCM replacement will require reprogramming.

Similar Problems

Accelerator Pedal Position (APP) Sensor 1 Performance
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage
Kick-Down Switch Failed Short

C2068 Troubleshooting

If this is the case with the code, you will be hearing very loud noises, like explosions, from the rear of the vehicle upon acceleration. Firstly check the carburetor to ensure that the fuel and air combination are properly balanced. If these settings are correct, then thoroughly inspect the distributor cap for any cracks or hairline splits, as this can produce a backfire. Move on to the spark plugs and ensure that they are clean and undamaged and inspect the engine gaskets for any sign of damage, as they are responsible for ensuring the correct gas exchange within the engine. C2068 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to turn off C2068 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.