B1413 Code:

OBD-II Diagnostic Body (B) Trouble Code

Possible Cause

The reason of B1413 is system wiring, connectors, or other electrical components are also subject to failure. When this code is set, it is imperative that the transmission be checked prior to further vehicle operation.

Common Symptoms

  1. Repair or replace damaged, disconnected, shorted, or corroded wiring, connectors, and components as necessary
  2. Engine and transmission ground cables, straps, and wires are sometimes left dangling after repairs are performed
  3. Several tools will be instrumental in successfully diagnosing this code
  4. There are several tools which will be instrumental in attempting to successfully diagnose the conditions which contribute to this code being stored

Similar Problems

Ignition System Or Misfire
Vehicle Speed Output Circuit
A/C System High Pressure High Temperature

B1413 Troubleshooting

When you put your foot down on the brakes you expect your car to quietly slow down and come to a stop. The power your foot applies on the brake pedal is assisted by hydraulic pressure. Your foot's force engages a piston and caliper with brake pads attached (bonded abrasive and heat resistance metal or ceramic) to put pressure on the rotor. B1413 OBD2 specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.

How to turn off B1413 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.