B0367 Code:

OBD-II Diagnostic Body (B) Trouble Code

Possible Cause

To know real cause of B0367 based of if this code is present in your two-wheel drive vehicle, suspect a faulty PCM or programming error. In most four wheel drive applications the four-wheel drive switch is used to switch between two and four wheel drive operation, as well as between low and high ranges

Common Symptoms

  1. Repair or replace system circuitry, connectors, and/or components that fail to coincide with manufacturer's specs
  2. Test the wiring and connectors at the fuel shutoff valve to make sure that voltage and ground readings are near battery voltage
  3. Some applications are equipped with up to 18 separate control modules. If you choose to tackle this monumental task, begin with a careful visual inspection of all system circuitry, connectors, and fuses
  4. The sensor is of the electro magnetic design and uses a reluctor ring (or a specialized set of splines) on the input shaft as reference points

Similar Problems

Fuel And Air Metering (Injector Circuit Malfunctions Only)
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage
PCM Stack Overrun

B0367 Troubleshooting

Having one of the signs of a bad gasket is usually not enough to prove a failure of a gasket, but multiple symptoms are most likely the result of gasket failure. It is advisable to have the vehicle driven as little as possible whenever the symptoms occur. Depending on the symptoms, either have the gasket replaced or repaired.
The cost of replacing a gasket usually varies from one mechanic to the other. Replacing a gasket is quite expensive in modern engines due to their location and the amount of labor that is required to replace them. B0367 OBD2 reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.

How to turn off B0367 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.