Willys-Overland Rural C2937 Code:

OBD-II Diagnostic Chassis (C) Trouble Code

Trouble In Willys-Overland Rural C2937 Possible Cause

The reason for Willys-Overland Rural C2937 the speedometer may fluctuate wildly or fail to operate, the engine may stall when coming to a stop, engine misfire, sag, stall, or hesitation, a stored code, and possibly an illuminated service engine soon lamp.

Common Symptoms For Willys-Overland Rural C2937

  1. Intermittent conditions can prove to be quite a challenge to diagnose and in extreme cases may have to be allowed to worsen before a correct diagnosis can even be attempted
  2. This signal is systematically forwarded to affected control modules that utilize the data to accomplish various other tasks
  3. Many scanners will permit the technician to retrieve these alpha numeric numbers (or codes) prior to controller replacement
  4. As exhaust temperature decreases (with the engine off), circuit resistance increases and the feedback voltage signal to the PCM decreases

Similar Problems

IC Module 4X Ref Circuit Intermittent, No Pulses
Crankshaft Position Sensor Circuit Performance
PCM Stack Overrun

Willys-Overland Rural C2937 Troubleshooting

If this is the case with the code, you will be hearing very loud noises, like explosions, from the rear of the vehicle upon acceleration. Firstly check the carburetor to ensure that the fuel and air combination are properly balanced. If these settings are correct, then thoroughly inspect the distributor cap for any cracks or hairline splits, as this can produce a backfire. Move on to the spark plugs and ensure that they are clean and undamaged and inspect the engine gaskets for any sign of damage, as they are responsible for ensuring the correct gas exchange within the engine. Willys-Overland Rural C2937 OBD2 reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.

How to turn off Willys-Overland Rural C2937 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.