Toyota RunX P0A05 Code:

OBD-II Diagnostic Powertrain (P) Trouble Code

Trouble In Toyota RunX P0A05 Possible Cause

The reason of Toyota RunX P0A05 is system wiring, connectors, or other electrical components are also subject to failure. When this code is set, it is imperative that the transmission be checked prior to further vehicle operation.

Common Symptoms For Toyota RunX P0A05

  1. Individual control module failure is rare but possible
  2. If either the reference voltage or ground circuits are open, use the digital volt/ohmmeter to check for continuity (disconnect all related control modules from the circuit before checking circuit resistance or controller damage may occur) and resistance in all circuits
  3. After the codes are cleared, test drive the vehicle to see if the code returns
  4. If the code fails to immediately return, you may have an intermittent condition

Similar Problems

Transmission
Control Module Throttle Actuator Position Performance
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit

Toyota RunX P0A05 Troubleshooting

Broken engine mountings can cause banging and graunching noises. There are two main types of mounting those centrally placed close to the bottom of the block and those higher up the block which mount on to the inner wings or chassis members. Toyota RunX P0A05 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to turn off Toyota RunX P0A05 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.