Toyota Caserta P3746 Code:

OBD-II Diagnostic Powertrain (P) Trouble Code

Trouble In Toyota Caserta P3746 Possible Cause

By far the most common cause of this Toyota Caserta P3746 code is from worn or defective transmission shifter components. Other causes may include a defective range sensor, open, shorted, corroded, or otherwise damaged wiring and/or electrical connectors.

Common Symptoms For Toyota Caserta P3746

  1. A specialized diagnostic CAN scanner will show pin values and control module operation without risking a meltdown
  2. A suitable OBD-II scanner (or code reader) and a digital volt/ohmmeter will be most helpful in performing a successful diagnosis
  3. If the initial resistance is within specifications, leave the leads of the digital volt/ohmmeter connected and heat the resistor with a heat gun
  4. Check local, state, and federal laws before removing emission related components.

Similar Problems

Vehicle Speed Control And Idle Control System
IC Circuit High Voltage
Cruise Inhibit Control Circuit

Toyota Caserta P3746 Troubleshooting

A sure sign of this is smoke or steam being emitted from underneath the hood. The ignition timing could be set incorrectly and will require adjustment. If, when looking under the hood, you notice that the drive belts appear loose, they need to be tightened or completely replaced. If there is a noticeable pool of fluid underneath the car, this could be a sign of the cylinder head gasket failing. That will be confirmed in the form of billowing smoke being blown from the exhaust system. Toyota Caserta P3746 the main thing to check is to verify the operation of the VCT solenoid. You're looking for a sticking or stuck VCt solenoid valve caused by contamination. Refer to vehicle specific repair manual to perform component tests for the VCT unit.

How to turn off Toyota Caserta P3746 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.