Suzuki Reno P356B Code:

OBD-II Diagnostic Powertrain (P) Trouble Code

Trouble In Suzuki Reno P356B Possible Cause

Possible causes of Suzuki Reno P356B include a faulty oxygen sensor, faulty electrical connector at the oxygen sensor, faulty or shorted wiring in the oxygen sensor circuit, a blown fuse for the oxygen sensor (if applicable), low or excessive fuel pressure, a vacuum leak on the engine, excessive exhaust leaks, or a faulty PCM.

Common Symptoms For Suzuki Reno P356B

  1. Begin with a visual inspection of all wiring and connectors
  2. Unlike other diagnostic codes, this type of code can sometimes be best left to a professional simply because of the bulk of circuitry involved
  3. The PCM will read the sensor resistance and pass it
  4. Typical causes of low pump pressure include clogged hydraulic passages, a defective pump, faulty shift solenoids, or a faulty electronic pressure regulator

Similar Problems

Transmission
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage
TFP Valve Position Switch-Drive Without Drive Ratio

Suzuki Reno P356B Troubleshooting

Broken engine mountings can cause banging and graunching noises. There are two main types of mounting those centrally placed close to the bottom of the block and those higher up the block which mount on to the inner wings or chassis members. Suzuki Reno P356B OBD2 reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.

How to turn off Suzuki Reno P356B check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.