Subaru SAGRES P318D Code:

OBD-II Diagnostic Powertrain (P) Trouble Code

Trouble In Subaru SAGRES P318D Possible Cause

Common causes of Subaru SAGRES P318D include a faulty electronic pressure control solenoid, hydraulic blockages inside the internal transmission fluid passages, mechanical internal transmission failures, low transmission fluid, dirty or contaminated transmission fluid, a faulty PCM or transmission control module.

Common Symptoms For Subaru SAGRES P318D

  1. It can accurately diagnose computer and circuitry problems by monitoring vehicle operation while the vehicle is being operated
  2. As the input shaft is turned (by the engine) the electro magnetic input/turbine speed sensor uses the spaces between the splines to provide voltage signal interruptions in the circuit
  3. Many vehicle applications utilize an electronically controlled valve in the automatic transmission cooler lines to regulate the flow of fluid to the cooler itself
  4. Several tools will be instrumental in successfully diagnosing this code

Similar Problems

Transmission
TP Sensor Learn Not Complete
TFP Valve Position Switch-Drive Without Drive Ratio

Subaru SAGRES P318D Troubleshooting

Having one of the signs of a bad gasket is usually not enough to prove a failure of a gasket, but multiple symptoms are most likely the result of gasket failure. It is advisable to have the vehicle driven as little as possible whenever the symptoms occur. Depending on the symptoms, either have the gasket replaced or repaired.
The cost of replacing a gasket usually varies from one mechanic to the other. Replacing a gasket is quite expensive in modern engines due to their location and the amount of labor that is required to replace them. Subaru SAGRES P318D OBD2 reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.

How to turn off Subaru SAGRES P318D check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.