Rochet-Schneider 18 U1533 Code:

OBD-II Diagnostic Network (U) Trouble Code

Trouble In Rochet-Schneider 18 U1533 Possible Cause

The most common causes of this Rochet-Schneider 18 U1533 code being stored are due to a defective input speed sensor or output speed sensor. Other common causes include shorted, open, corroded, or damaged wiring circuits or connectors.

Common Symptoms For Rochet-Schneider 18 U1533

  1. Intermittent conditions can prove to be quite a challenge to diagnose and in extreme cases may have to be allowed to worsen before a correct diagnosis can be made
  2. If either the reference voltage or ground circuits are open, use the digital volt/ohmmeter to check for continuity (disconnect all related control modules from the circuit before checking circuit resistance or controller damage may occur) and resistance in all circuits
  3. Many vehicle applications utilize an electronically controlled valve in the automatic transmission cooler lines to regulate the flow of fluid to the cooler itself
  4. If the code fails to immediately return, you may have an intermittent condition

Similar Problems

Transmission
Crankshaft Position Sensor Circuit Performance
A/C System High Pressure High Temperature

Rochet-Schneider 18 U1533 Troubleshooting

Having one of the signs of a bad gasket is usually not enough to prove a failure of a gasket, but multiple symptoms are most likely the result of gasket failure. It is advisable to have the vehicle driven as little as possible whenever the symptoms occur. Depending on the symptoms, either have the gasket replaced or repaired.
The cost of replacing a gasket usually varies from one mechanic to the other. Replacing a gasket is quite expensive in modern engines due to their location and the amount of labor that is required to replace them. Rochet-Schneider 18 U1533 OBD2 reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.

How to turn off Rochet-Schneider 18 U1533 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.