Renault Kangoo P02B0 Code:

OBD-II Diagnostic Powertrain (P) Trouble Code

Trouble In Renault Kangoo P02B0 Possible Cause

Common causes of Renault Kangoo P02B0 is include shorted, open, corroded, or damaged wiring circuits or connectors, faulty shift solenoid/s, defective engine drivability sensors (especially the engine temperature sensor), dirty or contaminated transmission fluid that restricts flow, defective valve body, a faulty PCM. PCM failure is rare.

Common Symptoms For Renault Kangoo P02B0

  1. Exhaust after treatment fuel injector systems are used exclusively in diesel applications. Exhaust after treatment fuel injector systems use either water, a chemical agent, air, or a combination of the three to reduce exhaust emissions in automotive applications by reducing exhaust temperature and/or exhaust pressure in the diesel particulate filter or catalytic converter assembly
  2. This will help to determine whether or not the malfunction is intermittent. After the codes are cleared, test drive the vehicle to see if the code returns
  3. Several tools will be instrumental in successfully diagnosing this code
  4. Should all system circuitry and sensors check out and the transmission is in good working order, suspect a faulty PCM but keep in mind that PCM failure is rare and PCM replacement will require reprogramming.

Similar Problems

Fuel And Air Metering
BBV Sensor Circuit Low Voltage
Transmission Engaged At High Throttle Angle

Renault Kangoo P02B0 Troubleshooting

Having one of the signs of a bad gasket is usually not enough to prove a failure of a gasket, but multiple symptoms are most likely the result of gasket failure. It is advisable to have the vehicle driven as little as possible whenever the symptoms occur. Depending on the symptoms, either have the gasket replaced or repaired.
The cost of replacing a gasket usually varies from one mechanic to the other. Replacing a gasket is quite expensive in modern engines due to their location and the amount of labor that is required to replace them. Renault Kangoo P02B0 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to turn off Renault Kangoo P02B0 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.