Renault Espider B2430 Code:

OBD-II Diagnostic Body (B) Trouble Code

Trouble In Renault Espider B2430 Possible Cause

The most common cause for this Renault Espider B2430 type of failure is due to liquids spilled on the upshift/downshift switch. Open or shorted electrical wiring, damaged, corroded, or disconnected wiring or connectors are also a viable possibility.

Common Symptoms For Renault Espider B2430

  1. For example: The PCM receives an input signal from the vehicle speed sensor
  2. If either the reference voltage or ground circuits are open, use the digital volt/ohmmeter to check for continuity (disconnect all related control modules from the circuit before checking circuit resistance or controller damage may occur) and resistance in all circuits
  3. Several tools will be instrumental in successfully diagnosing this code
  4. If the code fails to immediately return, you may have an intermittent condition

Similar Problems

Ignition System Or Misfire
Crankshaft Position Sensor Circuit Performance
Transmission Engaged At High Throttle Angle

Renault Espider B2430 Troubleshooting

Broken engine mountings can cause banging and graunching noises. There are two main types of mounting those centrally placed close to the bottom of the block and those higher up the block which mount on to the inner wings or chassis members. Renault Espider B2430 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to turn off Renault Espider B2430 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.