Plymouth Gran+Fury C1633 Code:

OBD-II Diagnostic Chassis (C) Trouble Code

Trouble In Plymouth Gran+Fury C1633 Possible Cause

Plymouth Gran+Fury C1633code will be stored and a malfunction indicator lamp may be illuminated. Some vehicles will require multiple failure cycles in order for the malfunction indicator lamp to be illuminated.

Common Symptoms For Plymouth Gran+Fury C1633

  1. This type of code usually represents a malfunction in the controller area network, or "CAN"
  2. If the resistance level does not decrease with heat and increase as it cools, replace the sensor. If everything has checked out thus far, turn the key to the "ON" position and test for the presence of a voltage (and a ground signal) at the exhaust gas temperature/pressure (or heated oxygen) sensor electrical connector
  3. A scanner (or code reader) and a digital volt/ohmmeter will be required to successfully diagnose this code. Virtually every vehicle (with an automatic transmission) produced since the mid-eighties is equipped with some type of computer controlled automatic transmission system
  4. If the fuel shutoff switch and all system circuitry checks out, suspect a defective PCM (or other related controller)

Similar Problems

Auxiliary Emission Controls
Crankshaft Position Sensor Circuit Performance
A/C System High Pressure High Temperature

Plymouth Gran+Fury C1633 Troubleshooting

Having one of the signs of a bad gasket is usually not enough to prove a failure of a gasket, but multiple symptoms are most likely the result of gasket failure. It is advisable to have the vehicle driven as little as possible whenever the symptoms occur. Depending on the symptoms, either have the gasket replaced or repaired.
The cost of replacing a gasket usually varies from one mechanic to the other. Replacing a gasket is quite expensive in modern engines due to their location and the amount of labor that is required to replace them. Plymouth Gran+Fury C1633 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to turn off Plymouth Gran+Fury C1633 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.