Pininfarina Osee P2514 Code:

OBD-II Diagnostic Powertrain (P) Trouble Code

Trouble In Pininfarina Osee P2514 Possible Cause

By far the most common cause of this Pininfarina Osee P2514 code is from worn or defective transmission shifter components. Other causes may include a defective range sensor, open, shorted, corroded, or otherwise damaged wiring and/or electrical connectors.

Common Symptoms For Pininfarina Osee P2514

  1. The exhaust gas temperature sensor is used in diesel engines, gasoline burning engines, and even turbocharged engines
  2. If the resistance level does not decrease with heat and increase as it cools, replace the sensor. If everything has checked out thus far, turn the key to the "ON" position and test for the presence of a voltage (and a ground signal) at the exhaust gas temperature/pressure (or heated oxygen) sensor electrical connector
  3. Many vehicle applications utilize an electronically controlled valve in the automatic transmission cooler lines to regulate the flow of fluid to the cooler itself
  4. If the fuel shutoff switch and all system circuitry checks out, suspect a defective PCM (or other related controller)

Similar Problems

Transmission
Vehicle Speed Output Circuit
Transmission Control Module Reprogrammable Memory

Pininfarina Osee P2514 Troubleshooting

Having one of the signs of a bad gasket is usually not enough to prove a failure of a gasket, but multiple symptoms are most likely the result of gasket failure. It is advisable to have the vehicle driven as little as possible whenever the symptoms occur. Depending on the symptoms, either have the gasket replaced or repaired.
The cost of replacing a gasket usually varies from one mechanic to the other. Replacing a gasket is quite expensive in modern engines due to their location and the amount of labor that is required to replace them. Pininfarina Osee P2514 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to turn off Pininfarina Osee P2514 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.