Peugeot 104 P325C Code:

OBD-II Diagnostic Powertrain (P) Trouble Code

Trouble In Peugeot 104 P325C Possible Cause

Common causes of Peugeot 104 P325C include four-wheel drive switch or actuator failures. Other causes include faulty sensors, solenoids, or switches, and defective wiring harnesses and connectors.

Common Symptoms For Peugeot 104 P325C

  1. This type of code is limited to applications with diesel engines
  2. Engine and transmission ground cables, straps, and wires are sometimes left dangling after repairs are performed
  3. CAN is the abbreviation for "controller area network." The CAN represents a communication bus that allows multiple microcontrollers to communicate with one another without the need for a host computer
  4. There are several tools which will be instrumental in attempting to successfully diagnose the conditions which contribute to this code being stored

Similar Problems

Fuel And Air Metering
Low Coolant Circuit
TFP Valve Position Switch-Drive Without Drive Ratio

Peugeot 104 P325C Troubleshooting

Having one of the signs of a bad gasket is usually not enough to prove a failure of a gasket, but multiple symptoms are most likely the result of gasket failure. It is advisable to have the vehicle driven as little as possible whenever the symptoms occur. Depending on the symptoms, either have the gasket replaced or repaired.
The cost of replacing a gasket usually varies from one mechanic to the other. Replacing a gasket is quite expensive in modern engines due to their location and the amount of labor that is required to replace them. Peugeot 104 P325C OBD2 reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.

How to turn off Peugeot 104 P325C check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.