NSU 1000 C1329 Code:

OBD-II Diagnostic Chassis (C) Trouble Code

Trouble In NSU 1000 C1329 Possible Cause

The reason of NSU 1000 C1329 is system wiring, connectors, or other electrical components are also subject to failure. When this code is set, it is imperative that the transmission be checked prior to further vehicle operation.

Common Symptoms For NSU 1000 C1329

  1. Exhaust after treatment fuel injector systems are used exclusively in diesel applications. Exhaust after treatment fuel injector systems use either water, a chemical agent, air, or a combination of the three to reduce exhaust emissions in automotive applications by reducing exhaust temperature and/or exhaust pressure in the diesel particulate filter or catalytic converter assembly
  2. As the input shaft is turned (by the engine) the electro magnetic input/turbine speed sensor uses the spaces between the splines to provide voltage signal interruptions in the circuit
  3. The exhaust gas temperature sensor is used in diesel engines, gasoline burning engines, and even turbocharged engines
  4. Several tools will be instrumental in successfully diagnosing this code

Similar Problems

Fuel And Air Metering (Injector Circuit Malfunctions Only)
Exhaust Gas Recirculation System Valve 1
TFP Valve Position Switch-Drive Without Drive Ratio

NSU 1000 C1329 Troubleshooting

Having one of the signs of a bad gasket is usually not enough to prove a failure of a gasket, but multiple symptoms are most likely the result of gasket failure. It is advisable to have the vehicle driven as little as possible whenever the symptoms occur. Depending on the symptoms, either have the gasket replaced or repaired.
The cost of replacing a gasket usually varies from one mechanic to the other. Replacing a gasket is quite expensive in modern engines due to their location and the amount of labor that is required to replace them. NSU 1000 C1329 OBD2 reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.

How to turn off NSU 1000 C1329 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.