Nissan Pulsar P002C Code:

OBD-II Diagnostic Powertrain (P) Trouble Code

Trouble In Nissan Pulsar P002C Possible Cause

Common causes of Nissan Pulsar P002C is include shorted, open, corroded, or damaged wiring circuits or connectors, faulty shift solenoid/s, defective engine drivability sensors (especially the engine temperature sensor), dirty or contaminated transmission fluid that restricts flow, defective valve body, a faulty PCM. PCM failure is rare.

Common Symptoms For Nissan Pulsar P002C

  1. The inlet door is typically closed when the key is placed in the OFF position and opened when the key is turned to the ON position
  2. Test the wiring and connectors at the fuel shutoff valve to make sure that voltage and ground readings are near battery voltage
  3. Pay particular attention to wiring and connectors that have been contaminated due to engine oil or transmission fluid leaks, burned on hot exhaust pipes, or damaged due to road debris. Inconsistencies between the input and output speed sensor readings may be interpreted by the PCM as a transmission friction element application malfunction
  4. The sensor is of the electro magnetic design and uses a reluctor ring (or a specialized set of splines) on the input shaft as reference points

Similar Problems

Accelerator Pedal Position (APP) Sensor 1 Performance
Exhaust Gas Recirculation System Valve 1
TFP Valve Position Switch-Drive Without Drive Ratio

Nissan Pulsar P002C Troubleshooting

When you put your foot down on the brakes you expect your car to quietly slow down and come to a stop. The power your foot applies on the brake pedal is assisted by hydraulic pressure. Your foot's force engages a piston and caliper with brake pads attached (bonded abrasive and heat resistance metal or ceramic) to put pressure on the rotor. Nissan Pulsar P002C OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to turn off Nissan Pulsar P002C check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.