Nissan Bassara U1439 Code:

OBD-II Diagnostic Network (U) Trouble Code

Trouble In Nissan Bassara U1439 Possible Cause

Nissan Bassara U1439 leads to an unsuccessful repair. Engine misfire codes, lean exhaust codes, fuel injector codes, and virtually any other drivability or transmission code that is accompanied by a controller communication code can potentially be a pitfall for misdiagnosis.

Common Symptoms For Nissan Bassara U1439

  1. Repair or replace any open, shorted, damaged, or corroded items as required and retest the system to make sure that repairs were successful
  2. Engine and transmission ground cables, straps, and wires are sometimes left dangling after repairs are performed
  3. Some applications also utilize the inlet door to regulate air flow through the intake tube by adjusting the degree to which the door opens according to throttle position
  4. There are several tools which will be instrumental in attempting to successfully diagnose the conditions which contribute to this code being stored

Similar Problems

Ignition System Or Misfire
Crankshaft Position Sensor Circuit Performance
TFP Valve Position Switch-Drive Without Drive Ratio

Nissan Bassara U1439 Troubleshooting

If this is the case with the code, you will be hearing very loud noises, like explosions, from the rear of the vehicle upon acceleration. Firstly check the carburetor to ensure that the fuel and air combination are properly balanced. If these settings are correct, then thoroughly inspect the distributor cap for any cracks or hairline splits, as this can produce a backfire. Move on to the spark plugs and ensure that they are clean and undamaged and inspect the engine gaskets for any sign of damage, as they are responsible for ensuring the correct gas exchange within the engine. Nissan Bassara U1439 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to turn off Nissan Bassara U1439 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.