Moretti 2500 C1773 Code:

OBD-II Diagnostic Chassis (C) Trouble Code

Trouble In Moretti 2500 C1773 Possible Cause

By far the most common cause of this Moretti 2500 C1773 code is from worn or defective transmission shifter components. Other causes may include a defective range sensor, open, shorted, corroded, or otherwise damaged wiring and/or electrical connectors.

Common Symptoms For Moretti 2500 C1773

  1. Look for loose or corroded electrical connectors that may increase circuit resistance and cause these types of codes to be stored. Obtain a CAN bus system wiring diagram and/or pin out value chart, then use the digital volt ohmmeter to test continuity between individual controller connectors
  2. Unlike other diagnostic codes, this type of code can sometimes be best left to a professional simply because of the bulk of circuitry involved
  3. Typical causes of low pump pressure include clogged hydraulic passages, a defective pump, faulty shift solenoids, or a faulty electronic pressure regulator
  4. Typical causes of low pump pressure include clogged hydraulic passages, a defective pump, faulty shift solenoids, or a faulty electronic pressure regulator

Similar Problems

Vehicle Speed Control And Idle Control System
Cruise Control Servo Indicates Low
A/C System High Pressure High Temperature

Moretti 2500 C1773 Troubleshooting

Having one of the signs of a bad gasket is usually not enough to prove a failure of a gasket, but multiple symptoms are most likely the result of gasket failure. It is advisable to have the vehicle driven as little as possible whenever the symptoms occur. Depending on the symptoms, either have the gasket replaced or repaired.
The cost of replacing a gasket usually varies from one mechanic to the other. Replacing a gasket is quite expensive in modern engines due to their location and the amount of labor that is required to replace them. Moretti 2500 C1773 OBD2 specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.

How to turn off Moretti 2500 C1773 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.