Mazda CX-9 C3251 Code:

OBD-II Diagnostic Chassis (C) Trouble Code

Trouble In Mazda CX-9 C3251 Possible Cause

The most common causes of Mazda CX-9 C3251 code being stored are due to a defective intermediate shaft speed sensor, output speed sensor, or input speed sensor.

Common Symptoms For Mazda CX-9 C3251

  1. Intermittent conditions can prove to be quite a challenge to diagnose and in extreme cases may have to be allowed to worsen before a correct diagnosis can be made. If the fuel shutoff valve has not been deactivated by a collision, use the digital volt/ohmmeter to test voltage and ground signals at the valve itself
  2. Engine and transmission ground cables, straps, and wires are sometimes left dangling after repairs are performed
  3. This signal is systematically forwarded to affected control modules that utilize the data to accomplish various other tasks
  4. There are several tools which will be instrumental in attempting to successfully diagnose the conditions which contribute to this code being stored

Similar Problems

Fuel And Air Metering
Low Coolant Circuit
Cruise Vehicle Speed/Set Speed Difference Too High

Mazda CX-9 C3251 Troubleshooting

If this is the case with the code, you will be hearing very loud noises, like explosions, from the rear of the vehicle upon acceleration. Firstly check the carburetor to ensure that the fuel and air combination are properly balanced. If these settings are correct, then thoroughly inspect the distributor cap for any cracks or hairline splits, as this can produce a backfire. Move on to the spark plugs and ensure that they are clean and undamaged and inspect the engine gaskets for any sign of damage, as they are responsible for ensuring the correct gas exchange within the engine. Mazda CX-9 C3251 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to turn off Mazda CX-9 C3251 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.