Maserati Mexico B205E Code:

OBD-II Diagnostic Body (B) Trouble Code

Trouble In Maserati Mexico B205E Possible Cause

Possible causes of Maserati Mexico B205E include a faulty oxygen sensor, faulty electrical connector at the oxygen sensor, faulty or shorted wiring in the oxygen sensor circuit, a blown fuse for the oxygen sensor (if applicable), low or excessive fuel pressure, a vacuum leak on the engine, excessive exhaust leaks, or a faulty PCM.

Common Symptoms For Maserati Mexico B205E

  1. Repair or replace circuitry, connectors, and/or components as required
  2. This will help to determine whether or not the malfunction is intermittent. After the codes are cleared, test drive the vehicle to see if the code returns
  3. If the fluid smells or appears burned, remove the transmission pan and check for the presence of clutch material and other debris
  4. Should all system circuitry and sensors check out and the transmission is in good working order, suspect a faulty PCM but keep in mind that PCM failure is rare and PCM replacement will require reprogramming.

Similar Problems

Accelerator Pedal Position (APP) Sensor 1 Performance
Low Coolant Circuit
TFP Valve Position Switch-Drive Without Drive Ratio

Maserati Mexico B205E Troubleshooting

When you put your foot down on the brakes you expect your car to quietly slow down and come to a stop. The power your foot applies on the brake pedal is assisted by hydraulic pressure. Your foot's force engages a piston and caliper with brake pads attached (bonded abrasive and heat resistance metal or ceramic) to put pressure on the rotor. Maserati Mexico B205E OBD2 reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.

How to turn off Maserati Mexico B205E check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.