Jensen Interceptor U246U Code:

OBD-II Diagnostic Network (U) Trouble Code

Trouble In Jensen Interceptor U246U Possible Cause

The reason for Jensen Interceptor U246U the speedometer may fluctuate wildly or fail to operate, the engine may stall when coming to a stop, engine misfire, sag, stall, or hesitation, a stored code, and possibly an illuminated service engine soon lamp.

Common Symptoms For Jensen Interceptor U246U

  1. An experienced technician with a specialized scanner (Autohex or Tech II) may be able to determine the general area of the malfunction much more rapidly and easily than someone using a code reader and a digital volt ohmmeter
  2. If either the reference voltage or ground circuits are open, use the digital volt/ohmmeter to check for continuity (disconnect all related control modules from the circuit before checking circuit resistance or controller damage may occur) and resistance in all circuits
  3. Many vehicle applications utilize an electronically controlled valve in the automatic transmission cooler lines to regulate the flow of fluid to the cooler itself
  4. If the code fails to immediately return, you may have an intermittent condition

Similar Problems

Ignition System Or Misfire
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage
TFP Valve Position Switch-Drive Without Drive Ratio

Jensen Interceptor U246U Troubleshooting

Having one of the signs of a bad gasket is usually not enough to prove a failure of a gasket, but multiple symptoms are most likely the result of gasket failure. It is advisable to have the vehicle driven as little as possible whenever the symptoms occur. Depending on the symptoms, either have the gasket replaced or repaired.
The cost of replacing a gasket usually varies from one mechanic to the other. Replacing a gasket is quite expensive in modern engines due to their location and the amount of labor that is required to replace them. Jensen Interceptor U246U OBD2 specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.

How to turn off Jensen Interceptor U246U check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.