Italdesign Formula P3539 Code:

OBD-II Diagnostic Powertrain (P) Trouble Code

Trouble In Italdesign Formula P3539 Possible Cause

Common cause for Italdesign Formula P3539 is the valve is controlled by the PCM (or a similar controller) using inputs from sensors and other controllers in the controller area network (CAN). The CAN represents a communication bus that allows multiple microcontrollers.

Common Symptoms For Italdesign Formula P3539

  1. This code is more likely the cause of a lack of fuel pressure rather than a reaction to it
  2. Unlike other diagnostic codes, this type of code can sometimes be best left to a professional simply because of the bulk of circuitry involved
  3. If the initial resistance is within specifications, leave the leads of the digital volt/ohmmeter connected and heat the resistor with a heat gun
  4. Typical causes of low pump pressure include clogged hydraulic passages, a defective pump, faulty shift solenoids, or a faulty electronic pressure regulator

Similar Problems

Transmission
Crankshaft Position Sensor Circuit Performance
TFP Valve Position Switch-Drive Without Drive Ratio

Italdesign Formula P3539 Troubleshooting

Having one of the signs of a bad gasket is usually not enough to prove a failure of a gasket, but multiple symptoms are most likely the result of gasket failure. It is advisable to have the vehicle driven as little as possible whenever the symptoms occur. Depending on the symptoms, either have the gasket replaced or repaired.
The cost of replacing a gasket usually varies from one mechanic to the other. Replacing a gasket is quite expensive in modern engines due to their location and the amount of labor that is required to replace them. Italdesign Formula P3539 OBD2 reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.

How to turn off Italdesign Formula P3539 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.