Honda Accord P0058 Code:

OBD-II Diagnostic Powertrain (P) Trouble Code

Trouble In Honda Accord P0058 Possible Cause

The most common cause for this Honda Accord P0058 type of failure is due to liquids spilled on the upshift/downshift switch. Open or shorted electrical wiring, damaged, corroded, or disconnected wiring or connectors are also a viable possibility.

Common Symptoms For Honda Accord P0058

  1. It can accurately diagnose computer and circuitry problems by monitoring vehicle operation while the vehicle is being operated
  2. A scanner (or code reader) and a digital volt/ohmmeter will be required to successfully diagnose this code. Virtually every vehicle (with an automatic transmission) produced since the mid-eighties is equipped with some type of computer controlled automatic transmission system
  3. If voltage and ground signals do not comply with manufacturer's recommendations (and all fuses and relays have been tested and passed) disconnect the fuel shutoff valve connector and all related control module connectors, then perform a continuity and resistance test on all related circuits

Similar Problems

Accelerator Pedal Position (APP) Sensor 1 Performance
Low Coolant Circuit
Kick-Down Switch Failed Short

Honda Accord P0058 Troubleshooting

Having one of the signs of a bad gasket is usually not enough to prove a failure of a gasket, but multiple symptoms are most likely the result of gasket failure. It is advisable to have the vehicle driven as little as possible whenever the symptoms occur. Depending on the symptoms, either have the gasket replaced or repaired.
The cost of replacing a gasket usually varies from one mechanic to the other. Replacing a gasket is quite expensive in modern engines due to their location and the amount of labor that is required to replace them. Honda Accord P0058 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to turn off Honda Accord P0058 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.