Goliath GP C3910 Code:

OBD-II Diagnostic Chassis (C) Trouble Code

Trouble In Goliath GP C3910 Possible Cause

The cause of Goliath GP C3910 code is about if recent transmission repairs have been performed, suspect that the range sensor was not readjusted properly (if so equipped). Sensor retaining bolts should always be installed using thread locking compound to ensure proper torque longevity.

Common Symptoms For Goliath GP C3910

  1. The inlet door is typically closed when the key is placed in the OFF position and opened when the key is turned to the ON position
  2. Should all system circuitry and sensors check out and the transmission is in good working order, suspect a faulty PCM but keep in mind that PCM failure is rare and PCM replacement will require reprogramming.
  3. A scanner (or code reader) and a digital volt/ohmmeter will be required to successfully diagnose this code. Virtually every vehicle (with an automatic transmission) produced since the mid-eighties is equipped with some type of computer controlled automatic transmission system
  4. Individual control module failure is rare but possible

Similar Problems

IC Module 4X Ref Circuit Intermittent, No Pulses
Vehicle Speed Output Circuit
Transmission Engaged At High Throttle Angle

Goliath GP C3910 Troubleshooting

Having one of the signs of a bad gasket is usually not enough to prove a failure of a gasket, but multiple symptoms are most likely the result of gasket failure. It is advisable to have the vehicle driven as little as possible whenever the symptoms occur. Depending on the symptoms, either have the gasket replaced or repaired.
The cost of replacing a gasket usually varies from one mechanic to the other. Replacing a gasket is quite expensive in modern engines due to their location and the amount of labor that is required to replace them. Goliath GP C3910 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to turn off Goliath GP C3910 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.