Ferrari 801 C2016 Code:

OBD-II Diagnostic Chassis (C) Trouble Code

Trouble In Ferrari 801 C2016 Possible Cause

Possible causes of Ferrari 801 C2016 include a faulty oxygen sensor, faulty electrical connector at the oxygen sensor, faulty or shorted wiring in the oxygen sensor circuit, a blown fuse for the oxygen sensor (if applicable), low or excessive fuel pressure, a vacuum leak on the engine, excessive exhaust leaks, or a faulty PCM.

Common Symptoms For Ferrari 801 C2016

  1. Exhaust after treatment fuel injector systems are used exclusively in diesel applications. Exhaust after treatment fuel injector systems use either water, a chemical agent, air, or a combination of the three to reduce exhaust emissions in automotive applications by reducing exhaust temperature and/or exhaust pressure in the diesel particulate filter or catalytic converter assembly
  2. This will help to determine whether or not the malfunction is intermittent. After the codes are cleared, test drive the vehicle to see if the code returns
  3. Several tools will be instrumental in successfully diagnosing this code
  4. Should all system circuitry and sensors check out and the transmission is in good working order, suspect a faulty PCM but keep in mind that PCM failure is rare and PCM replacement will require reprogramming.

Similar Problems

Accelerator Pedal Position (APP) Sensor 1 Performance
Vehicle Speed Output Circuit
Cruise Inhibit Control Circuit

Ferrari 801 C2016 Troubleshooting

Having one of the signs of a bad gasket is usually not enough to prove a failure of a gasket, but multiple symptoms are most likely the result of gasket failure. It is advisable to have the vehicle driven as little as possible whenever the symptoms occur. Depending on the symptoms, either have the gasket replaced or repaired.
The cost of replacing a gasket usually varies from one mechanic to the other. Replacing a gasket is quite expensive in modern engines due to their location and the amount of labor that is required to replace them. Ferrari 801 C2016 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to turn off Ferrari 801 C2016 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.