Fairthorpe Atomata P2585 Code:

OBD-II Diagnostic Powertrain (P) Trouble Code

Trouble In Fairthorpe Atomata P2585 Possible Cause

Fairthorpe Atomata P2585 leads to an unsuccessful repair. Engine misfire codes, lean exhaust codes, fuel injector codes, and virtually any other drivability or transmission code that is accompanied by a controller communication code can potentially be a pitfall for misdiagnosis.

Common Symptoms For Fairthorpe Atomata P2585

  1. If the code fails to immediately return, you may have an intermittent condition
  2. If the resistance level does not decrease with heat and increase as it cools, replace the sensor. If everything has checked out thus far, turn the key to the "ON" position and test for the presence of a voltage (and a ground signal) at the exhaust gas temperature/pressure (or heated oxygen) sensor electrical connector
  3. If the initial resistance is within specifications, leave the leads of the digital volt/ohmmeter connected and heat the resistor with a heat gun
  4. If the fuel shutoff switch and all system circuitry checks out, suspect a defective PCM (or other related controller)

Similar Problems

Transmission
TP Sensor Learn Not Complete
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit

Fairthorpe Atomata P2585 Troubleshooting

If there is a clicking noise when you attempt to start the engine and the engine does not crank, it typically means there is something wrong with the battery, such as a low or discharged battery or corroded or loose battery cables. If the engine cranks when you attempt to start the car, but fails to turn over, this may mean there is a problem with the fuel or ignition. Other common reasons an engine may fail to start include a failure of the starter motor relay, a clogged fuel filter, a defective fuel pump or an ignition switch failure. Fairthorpe Atomata P2585 the main thing to check is to verify the operation of the VCT solenoid. You're looking for a sticking or stuck VCt solenoid valve caused by contamination. Refer to vehicle specific repair manual to perform component tests for the VCT unit.

How to turn off Fairthorpe Atomata P2585 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.