De Soto Powermaster P2961 Code:

OBD-II Diagnostic Powertrain (P) Trouble Code

Trouble In De Soto Powermaster P2961 Possible Cause

De Soto Powermaster P2961 code applies to vehicles equipped with dual clutch adaptive transmissions, automated manual transmissions, manual transmissions and automatic transmissions. Technicians also report the presence of excessive corrosion in the sensor connector as the cause of this code being stored.

Common Symptoms For De Soto Powermaster P2961

  1. After the codes are cleared, operate the vehicle to see if the code returns
  2. This signal is systematically forwarded to affected control modules that utilize the data to accomplish various other tasks
  3. Typical causes of low pump pressure include clogged hydraulic passages, a defective pump, faulty shift solenoids, or a faulty electronic pressure regulator
  4. As exhaust temperature decreases (with the engine off), circuit resistance increases and the feedback voltage signal to the PCM decreases

Similar Problems

IC Module 4X Ref Circuit Intermittent, No Pulses
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage
Cruise Vehicle Speed/Set Speed Difference Too High

De Soto Powermaster P2961 Troubleshooting

Having one of the signs of a bad gasket is usually not enough to prove a failure of a gasket, but multiple symptoms are most likely the result of gasket failure. It is advisable to have the vehicle driven as little as possible whenever the symptoms occur. Depending on the symptoms, either have the gasket replaced or repaired.
The cost of replacing a gasket usually varies from one mechanic to the other. Replacing a gasket is quite expensive in modern engines due to their location and the amount of labor that is required to replace them. De Soto Powermaster P2961 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to turn off De Soto Powermaster P2961 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.