Citroen Evasion P125C Code:

OBD-II Diagnostic Powertrain (P) Trouble Code

Trouble In Citroen Evasion P125C Possible Cause

Citroen Evasion P125Ccode will be stored and a malfunction indicator lamp may be illuminated. Some vehicles will require multiple failure cycles in order for the malfunction indicator lamp to be illuminated.

Common Symptoms For Citroen Evasion P125C

  1. If the numbers are properly retrieved, they can be reentered into the new controller upon replacement and no codes will be presented
  2. Test the wiring and connectors at the fuel shutoff valve to make sure that voltage and ground readings are near battery voltage
  3. As the reluctor ring passes by the electro magnetic sensor, the 5-volt reference signal is completed with the protruding metal surfaces
  4. The sensor is of the electro magnetic design and uses a reluctor ring (or a specialized set of splines) on the input shaft as reference points

Similar Problems

Fuel And Air Metering
Low Coolant Circuit
TFP Valve Position Switch-Drive Without Drive Ratio

Citroen Evasion P125C Troubleshooting

Having one of the signs of a bad gasket is usually not enough to prove a failure of a gasket, but multiple symptoms are most likely the result of gasket failure. It is advisable to have the vehicle driven as little as possible whenever the symptoms occur. Depending on the symptoms, either have the gasket replaced or repaired.
The cost of replacing a gasket usually varies from one mechanic to the other. Replacing a gasket is quite expensive in modern engines due to their location and the amount of labor that is required to replace them. Citroen Evasion P125C OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to turn off Citroen Evasion P125C check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.