Citroen Eole B2942 Code:

OBD-II Diagnostic Body (B) Trouble Code

Trouble In Citroen Eole B2942 Possible Cause

To know real cause of Citroen Eole B2942 based of if this code is present in your two-wheel drive vehicle, suspect a faulty PCM or programming error. In most four wheel drive applications the four-wheel drive switch is used to switch between two and four wheel drive operation, as well as between low and high ranges

Common Symptoms For Citroen Eole B2942

  1. Control module ground circuits should be tested for continuity with battery ground
  2. This signal is systematically forwarded to affected control modules that utilize the data to accomplish various other tasks
  3. Some applications also utilize the inlet door to regulate air flow through the intake tube by adjusting the degree to which the door opens according to throttle position
  4. As exhaust temperature decreases (with the engine off), circuit resistance increases and the feedback voltage signal to the PCM decreases

Similar Problems

IC Module 4X Ref Circuit Intermittent, No Pulses
IC Circuit High Voltage
Cruise Control System - Vehicle Accel Too High

Citroen Eole B2942 Troubleshooting

Having one of the signs of a bad gasket is usually not enough to prove a failure of a gasket, but multiple symptoms are most likely the result of gasket failure. It is advisable to have the vehicle driven as little as possible whenever the symptoms occur. Depending on the symptoms, either have the gasket replaced or repaired.
The cost of replacing a gasket usually varies from one mechanic to the other. Replacing a gasket is quite expensive in modern engines due to their location and the amount of labor that is required to replace them. Citroen Eole B2942 OBD2 specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.

How to turn off Citroen Eole B2942 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.