Buick Park+Avenue P364E Code:

OBD-II Diagnostic Powertrain (P) Trouble Code

Trouble In Buick Park+Avenue P364E Possible Cause

Buick Park+Avenue P364E code applies to vehicles equipped with dual clutch adaptive transmissions, automated manual transmissions, manual transmissions and automatic transmissions. Technicians also report the presence of excessive corrosion in the sensor connector as the cause of this code being stored.

Common Symptoms For Buick Park+Avenue P364E

  1. Repair or replace open or shorted wiring and connectors as required. If there is no voltage present on the sensor connector and all system circuitry is functioning normally, suspect a faulty reductant injector air controller
  2. Look for shorted or burned wiring and replace circuitry and connectors as required
  3. A scanner (or code reader) and a digital volt/ohmmeter will be required to successfully diagnose this code. Virtually every vehicle (with an automatic transmission) produced since the mid-eighties is equipped with some type of computer controlled automatic transmission system
  4. To perform a thorough diagnosis, any transmission leaks should be repaired and the transmission should be filled with the proper amount and type of fluid (if the fluid smells really "burnt" and you are experienced enough to detect it, you may go ahead and condemn the transmission)

Similar Problems

Auxiliary Emission Controls
IC Circuit High Voltage
TFP Valve Position Switch-Drive Without Drive Ratio

Buick Park+Avenue P364E Troubleshooting

If this is the case with the code, you will be hearing very loud noises, like explosions, from the rear of the vehicle upon acceleration. Firstly check the carburetor to ensure that the fuel and air combination are properly balanced. If these settings are correct, then thoroughly inspect the distributor cap for any cracks or hairline splits, as this can produce a backfire. Move on to the spark plugs and ensure that they are clean and undamaged and inspect the engine gaskets for any sign of damage, as they are responsible for ensuring the correct gas exchange within the engine. Buick Park+Avenue P364E OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to turn off Buick Park+Avenue P364E check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.