Austin Seven P240D Code:

OBD-II Diagnostic Powertrain (P) Trouble Code

Trouble In Austin Seven P240D Possible Cause

To know real cause of Austin Seven P240D based of if this code is present in your two-wheel drive vehicle, suspect a faulty PCM or programming error. In most four wheel drive applications the four-wheel drive switch is used to switch between two and four wheel drive operation, as well as between low and high ranges

Common Symptoms For Austin Seven P240D

  1. At any rate, make sure that the fluid level is within manufacturer's specified recommendations and that the fluid is in good condition
  2. If either the reference voltage or ground circuits are open, use the digital volt/ohmmeter to check for continuity (disconnect all related control modules from the circuit before checking circuit resistance or controller damage may occur) and resistance in all circuits
  3. A scanner (or code reader) and a digital volt/ohmmeter will be required to successfully diagnose this code. Virtually every vehicle (with an automatic transmission) produced since the mid-eighties is equipped with some type of computer controlled automatic transmission system
  4. If the code fails to immediately return, you may have an intermittent condition

Similar Problems

Ignition System Or Misfire
Control Module Throttle Actuator Position Performance
TFP Valve Position Switch-Drive Without Drive Ratio

Austin Seven P240D Troubleshooting

Having one of the signs of a bad gasket is usually not enough to prove a failure of a gasket, but multiple symptoms are most likely the result of gasket failure. It is advisable to have the vehicle driven as little as possible whenever the symptoms occur. Depending on the symptoms, either have the gasket replaced or repaired.
The cost of replacing a gasket usually varies from one mechanic to the other. Replacing a gasket is quite expensive in modern engines due to their location and the amount of labor that is required to replace them. Austin Seven P240D OBD2 reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.

How to turn off Austin Seven P240D check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.