Aster 24 P0695 Code:

OBD-II Diagnostic Powertrain (P) Trouble Code

Trouble In Aster 24 P0695 Possible Cause

To know real cause of Aster 24 P0695 based of if this code is present in your two-wheel drive vehicle, suspect a faulty PCM or programming error. In most four wheel drive applications the four-wheel drive switch is used to switch between two and four wheel drive operation, as well as between low and high ranges

Common Symptoms For Aster 24 P0695

  1. The PCM then compares transmission output speed data with engine input speed data to determine shift patterns, as well as certain engine drivability functions. The typical output speed sensor uses a three-wire connector but check the vehicle manufacturer's wiring diagram to confirm the specific design of the vehicle in question
  2. If either the reference voltage or ground circuits are open, use the digital volt/ohmmeter to check for continuity (disconnect all related control modules from the circuit before checking circuit resistance or controller damage may occur) and resistance in all circuits
  3. If the initial resistance is within specifications, leave the leads of the digital volt/ohmmeter connected and heat the resistor with a heat gun
  4. If the code fails to immediately return, you may have an intermittent condition

Similar Problems

Auxiliary Emission Controls
BBV Sensor Circuit Low Voltage
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit

Aster 24 P0695 Troubleshooting

Having one of the signs of a bad gasket is usually not enough to prove a failure of a gasket, but multiple symptoms are most likely the result of gasket failure. It is advisable to have the vehicle driven as little as possible whenever the symptoms occur. Depending on the symptoms, either have the gasket replaced or repaired.
The cost of replacing a gasket usually varies from one mechanic to the other. Replacing a gasket is quite expensive in modern engines due to their location and the amount of labor that is required to replace them. Aster 24 P0695 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to turn off Aster 24 P0695 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.