Alfa Romeo Graduate B2389 Code:

OBD-II Diagnostic Body (B) Trouble Code

Trouble In Alfa Romeo Graduate B2389 Possible Cause

Common cause for Alfa Romeo Graduate B2389 is the valve is controlled by the PCM (or a similar controller) using inputs from sensors and other controllers in the controller area network (CAN). The CAN represents a communication bus that allows multiple microcontrollers.

Common Symptoms For Alfa Romeo Graduate B2389

  1. This code is more likely the cause of a lack of fuel pressure rather than a reaction to it
  2. Engine and transmission ground cables, straps, and wires are sometimes left dangling after repairs are performed
  3. Intermittent conditions can prove to be quite a challenge to diagnose and in extreme cases may have to be allowed to worsen before a correct diagnosis can even be attempted
  4. There are several tools which will be instrumental in attempting to successfully diagnose the conditions which contribute to this code being stored

Similar Problems

Fuel And Air Metering (Injector Circuit Malfunctions Only)
TP Sensor Learn Not Complete
TFP Valve Position Switch-Drive Without Drive Ratio

Alfa Romeo Graduate B2389 Troubleshooting

Having one of the signs of a bad gasket is usually not enough to prove a failure of a gasket, but multiple symptoms are most likely the result of gasket failure. It is advisable to have the vehicle driven as little as possible whenever the symptoms occur. Depending on the symptoms, either have the gasket replaced or repaired.
The cost of replacing a gasket usually varies from one mechanic to the other. Replacing a gasket is quite expensive in modern engines due to their location and the amount of labor that is required to replace them. Alfa Romeo Graduate B2389 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to turn off Alfa Romeo Graduate B2389 check engine light ?

There are two ways to turn off the check engine light:

A repair technician can do so once repairs have been made.
The OBD II can automatically turn it off when it fails to detect the problem after several diagnostic cycles.

EngineTroubles.com Logo

Copyright © 2017 | http://www.EngineTroubles.com | All Rights Reserved.